Step-by-Step Guide: Converting Your Mimaki TxF from OEM to Compatible DTF Ink

Mimaki PHT50 ink transition, TxF300-75 ink flushing guide, compatible DTF ink for Mimaki, Mimaki TxF150 maintenance 2026, PHT50 chip bypass.

In 2026, the cost of DTF production is the difference between a profitable shop and a struggling one. While the Mimaki TxF series is an engineering marvel, many owners are switching to premium compatible degassed ink bags to lower their overhead.

If done correctly, this transition is seamless and poses zero risk to your printheads. Follow this factory-verified protocol to ensure a successful conversion.

Phase 1: Pre-Conversion Checklist

Before you break the seal on your new compatible ink bags, verify the following:

  • Chip Version: Ensure your compatible bags feature the V10.2 smart chip (released early 2026) to bypass the latest firmware security.
  • Ink Type: Confirm the ink is PHT50-compatible textile pigment.
  • Nozzle Check: Perform a full nozzle wash and print a test pattern. NEVER switch inks on a machine with existing nozzle deflections.
  • Cleaning Liquid: Have a fresh bag of Mimaki-compatible flushing liquid (usually 600ml) ready.

Phase 2: The Step-by-Step Transition

Step 1: Drain the OEM Ink

Access the ink supply unit at the rear of the TxF.

  1. Remove the OEM CMYKW bags.
  2. Use the Maintenance Menu on your control panel to select [INK FILLING] or [CLEANING].
  3. Draw out the remaining OEM ink from the lines until the dampers are nearly empty.

Step 2: The Flushing Cycle (Crucial)

While many 2026 inks are “mixable,” we recommend a flush to prevent chemical reactions between different surfactant packages.

  1. Insert the Flushing Liquid bags into all slots.
  2. Run two [Hard Cleaning] cycles.
  3. Check the lines; they should appear clear. This ensures the MCT (Mimaki Circulation Technology) system is primed with neutral fluid.

Step 3: Installing the Compatible Bags

  1. Insert the Compatible PHT50 600ml/500ml Bags.
  2. The printer should display “Ink Detected” immediately. If you see a “Non-Original” warning, simply click “OK” or “Continue” (depending on your 2026 firmware version).

Step 4: Re-Priming the System

  1. Run the [INK FILLING] command again.
  2. The TxF will draw the new compatible ink through the degassed bags and into the sub-tanks.
  3. Perform a Nozzle Check. You may need one additional [Normal Cleaning] to ensure the color density is 100% consistent.

Phase 3: Post-Conversion Optimization

  • ICC Profiles: Most 2026 premium compatibles are “color-matched.” However, for the best results in RasterLink7, we recommend running a small color calibration strip to check the white ink opacity and CMYK vibrancy.
  • Agitation Settings: Ensure your White Ink Circulation settings remain active. Even the best compatible white ink requires the TxF’s internal mechanical agitation.
  • Wash Test: Print a 10″ x 10″ transfer, cure it, and perform a Standard 40°C Wash Test to verify the stretch-resistance and hand-feel.

Conclusion: Sustainable Profitability

By following this professional conversion path, you can reduce your consumable costs by 40–60% without compromising the industrial reliability of your Mimaki hardware.

Get Your Mimaki Conversion Kit

We offer complete transition bundles including CMYKW ink bags and the necessary flushing liquids at 2026 factory prices.

[Order Your Mimaki Conversion Bundle] | [Speak to a Technical Consultant]